Economic Advantages Failed to Offset Market Sentiment; Stainless Steel Scrap Declined This Week [SMM Stainless Steel Scrap Market Weekly Review]

Published: Mar 20, 2026 15:28

Save

This week, prices of 304 stainless steel scrap off-cuts in east China strengthened to 10,000-10,100 yuan/mt; prices of stainless steel scrap off-cuts of the same specification in Foshan also rose, with the price range at 9,600-9,900 yuan/mt. In terms of raw material production costs, the current cost of producing stainless steel entirely from stainless steel scrap was about 14,098.03 yuan/mt, while the cost of production using only high-grade NPI was 14,786.98 yuan/mt.

This week, stainless steel scrap prices fell back, mainly driven by macro sentiment disruptions, weak futures, and pressure on both supply and demand. Escalating geopolitical conflicts, coupled with hawkish remarks from the US Fed, dragged SS futures into the doldrums overall, with the bearish impact directly transmitted to the spot market. Stainless steel finished product prices also pulled back across the board, and market pessimism gradually spread. Prices of substitute raw materials also pulled back, while stainless steel mills showed a strong inclination to push for lower prices. NPI traders turned weaker in sentiment and sold at low prices, and the high-grade NPI market also softened. In addition, Tsingshan's April tender price for high-carbon ferrochrome was set low, not only below previous market expectations but also lower than current retail quotations, limiting room for ferrochrome prices to rise and eliminating the support from substitute raw materials for stainless steel scrap. Currently, inventory at stainless steel scrap yards remained relatively high. Coupled with tight tax invoice availability, stainless steel mills were not active in procurement tenders, and the procurement pace continued to slow down. Amid the resonance of multiple bearish factors, stainless steel scrap prices fell in line with futures and finished products. Although stainless steel scrap still maintained a clear economic advantage over high-grade NPI, under the overall weak market atmosphere, cost support was difficult to translate into price support and failed to reverse the downward price trend. Overall, the stainless steel scrap market this week showed a weak pattern of "futures drag, weaker raw materials, and pressure on supply and demand." In the short term, bearish factors are expected to dominate, and stainless steel scrap prices are expected to remain in the doldrums.

Data Source Statement: Except for publicly available information, all other data are processed by SMM based on publicly available information, market communication, and relying on SMM's internal database model. They are for reference only and do not constitute decision-making recommendations.

For any inquiries or for more information, please contact: lemonzhao@smm.cn

For more information on how to access our research reports, please contact:service.en@smm.cn

Related News

Jun 25, 2026 16:21

[SMM Stainless Steel Market Flash] EU Adds 'Melt and Pour' Origin Rule to Curb Steel Rerouting, Phased to 2028

Under the EU's new steel trade regime, importers must prove the 'country of melt and pour'—where steel or iron was first produced in liquid form and cast into its first solid state—to improve supply-chain traceability. Evidence such as a mill test certificate is required from 1 October 2026; melt-and-pour data will feed into country quota distribution from 1 October 2027; and by 30 June 2028 the Commission will assess whether to make melt-and-pour the basis for quota eligibility, possibly via a legislative proposal. The rule targets origin-washing, raising the cost of routing non-EU steel—including Chinese stainless—through third countries to dodge quotas and duties.

Jun 25, 2026 16:21

Jun 25, 2026 16:20

[SMM Stainless Steel Market Flash] EU Sets Stainless Quotas (496,342t CR, 153,186t HR) and 50% Over-Quota Duty

The EU's new steel trade regime (Regulation 2026/1384) applies from 1 July 2026, replacing the 2019 safeguard that expires 30 June and lifting the out-of-quota duty to 50% from 25%. Within an 18.35 million-tonne total annual tariff-rate quota, stainless gets category-specific caps: cold-rolled sheets and strips 496,342 t, hot-rolled sheets and strips 153,186 t, hot-rolled quarto plate 17,025 t, bars and light sections 133,595 t, wire rod 40,462 t, and seamless tubes and pipes 32,967 t—about 873,577 t of stainless in total. Quotas run 1 July–30 June and are administered quarterly. Once a category's quota fills, further imports face the 50% duty, double the prior 25% penalty, tightening access for non-EU stainless.

Jun 25, 2026 16:20

Jun 25, 2026 13:59

[SMM Stainless Steel Flash] EU New Steel Trade Regime Effective 1 July; Country Quota Allocations Still Pending

The European Commission published Regulation (EU) 2026/1384, establishing the EU steel trade regime that takes effect 1 July 2026 and replaces the safeguard measures expiring 30 June. The new framework sets annual tariff-rate quotas of 18.3 million mt with a 50% out-of-quota duty, and adds a melt-and-pour origin requirement to curb circumvention. Crucially, the country-specific quota allocations are not yet set: they will come via a separate implementing act that has not been published, even as talks with several FTA partners reportedly continue. The gap leaves importers and supply chains uncertain about how the quota system will function from day one, with stainless mills among those watching the final country splits.

Jun 25, 2026 13:59