SMM Morning Comments (Apr 13): Base Metals Closed with Gains on Lower-than-expected US Inflation Data

게시됨: Apr 13, 2023 10:00
출처: SMM
LME and SHFE base metals closed with gains last night.

SHANGHAI, Apr 13 (SMM) - LME and SHFE base metals closed with gains last night. On the macro front, the United States announced that the increase in CPI in March was lower than expected, making the market expect that the Fed may stop further rate hikes after raising interest rates in May, and the U.S. index dived lower, which is good for copper prices.

Copper: LME copper prices closed at $8,960/mt overnight, a rise of 0.78%. Trading volumes were 15,000 lots and open interest stood at 249,000 lots. The most active SHFE 2305 copper contract finished at 69,410 yuan/mt overnight, up 0.64%. Trading volume was 38,000 lots and open interest stood at 169,000 lots.

In terms of fundamentals, due to the narrowing of the price difference between the SHFE April copper contract and the May contract as the delivery approached, sellers raised their quotes. Most of the purchases were made on the dip yesterday. The overall trading was quiet. At present, the speed of domestic inventory destocking has slowed down. The support from fundamentals for copper prices has weakened. But the market optimism over domestic consumption improvement underpinned copper prices. The market expects that the United States will soon end the interest rate hike, and the pressure on copper prices will weaken. It is expected that copper prices still have room to rise.

Aluminium: Overnight, the most-traded SHFE 2305 aluminium contract opened at 18,440 yuan/mt, with its lowest and highest at 18,415 yuan/mt and 18,505 yuan/mt before closing at 18,480 yuan/mt, up 40 yuan/mt or 0.22%. LME aluminium opened at $2,306.5/mt on Wednesday, with its high and low at $2,333/mt and $2,290.5/mt respectively before closing at $2,324/mt, an increase of $21/mt or 0.91%.

The US inflation data was lower than expected, thus expectations for interest rate hike in May weakened. This sent the US dollar index lower, boosting base metals. The domestic aluminium supply maintained a small increase, while downstream demand is recovering slowly. On the whole, the short-term aluminium market is intertwined with positive and negative factors, which may keep aluminium prices rangebound. It is necessary to continue to pay attention to the power supply situation in Yunnan, inventory changes, and whether the Federal Reserve will raise interest rate.

Lead: Overnight, the LME lead prices opened at $2,092/mt and hit the highest point at $2,139/mt amid the lower-than-expected US inflation, up $42/mt, or 2.02%.

The most-traded SHFE lead contract opened at 15,330 yuan/mt and closed at 15,315 yuan/mt after hitting the highest point at 15,355 yuan/mt, an increase of 35 yuan/mt or 0.23%.

Zinc: LME zinc opened at $2,771.5/mt at last night’s session, hitting a low of $2,734.5/mt and a high of $2,796/mt, and closed at $2,793/mt, up $6.5/mt or 0.23%. Trading volume was reduced to 5,843 lots, and open interest lost 1,936 lots to 176,000 lots. LME zinc inventory decreased by 25 mt or 0.06% to 44,675 mt. The US CPI released last night was lower than expected, but the core CPI remained resilient, leading to a weaker dollar and rallying LME zinc prices.

Overnight, the most-traded SHFE 2305 zinc contract opened at 21,980 yuan/mt and closed at 22,065 yuan/mt, up 80 yuan/mt or 0.36%. Trading volume was down to 45,330 lots, and open interest shed 1,267 lots to 107,000 lots. SHFE zinc prices rose slightly trailing the growing LME zinc prices. However, its momentum will be insufficient amid slack downstream demand.

Nickel:On the supply side, downstream demand picked up slightly, but the spot premiums fell amid the rising futures prices. Imports of pure nickel still suffered losses. There are still some NPI inventories that have not been released, but the overall stocks decreased slightly, especially the inventory held by traders. On the demand side, there have been a lot of transactions in the market recently, which are mainly the pick-up of cargoes without B/L. The terminal companies restocked raw materials in a small amount each time. In general, pure nickel demand grew slightly, which may curb the nickel prices from further dropping.

[Disclaimer: The above representation and data is based on market information SMM believes to be reliable at the time of acquiring as well as the comprehensive assessment by SMM research team, and any and all information provided in this article is for reference only. This article does not constitute a direct recommendation for investment or any decisions in any form and clients shall act on their own discreet and any decisions made by clients are not within the responsibility of SMM.]

데이터 출처 설명: 공개 정보를 제외한 모든 데이터는 SMM이 공개 정보, 시장 커뮤니케이션 및 SMM 내부 데이터베이스 모델을 기반으로 가공한 것입니다. 본 자료는 참고용이며 의사결정 권고를 구성하지 않습니다.

문의 사항이 있거나 자세한 정보를 원하시면 아래로 연락해 주시기 바랍니다: lemonzhao@smm.cn
리서치 보고서 열람 방법에 대한 자세한 내용은 아래로 문의하시기 바랍니다:service.en@smm.cn
관련 뉴스
ACG 게디크테페 황화물 확장 프로젝트, 첫 구리·아연 정광 생산; 2026년 말까지 완전 생산 목표
13시간 전
ACG 게디크테페 황화물 확장 프로젝트, 첫 구리·아연 정광 생산; 2026년 말까지 완전 생산 목표
더 보기
ACG 게디크테페 황화물 확장 프로젝트, 첫 구리·아연 정광 생산; 2026년 말까지 완전 생산 목표
ACG 게디크테페 황화물 확장 프로젝트, 첫 구리·아연 정광 생산; 2026년 말까지 완전 생산 목표
ACG Metals는 9월 1일 튀르키예 소재 Gediktepe 광산에서 8월 31일 첫 구리 정광을 생산했다고 발표하며 증산 단계에 돌입했다고 밝혔다. 회사는 처리량을 점진적으로 늘리고 플랜트 성능을 최적화하여 2026년 말까지 완전 가동을 목표로 하고 있다. Gediktepe의 정상 상태 연간 생산 목표는 구리 환산 2만~2만 5천 톤이다. 전체 발표문에는 해당 광산이 2026년 8월 첫 아연 정광을 생산했다는 내용도 포함되었으나, 구체적인 날짜와 생산량은 공개되지 않았다. SMM은 2026년 해당 광산의 아연 정광 내 아연 함유량을 약 1만~1만 5천 톤으로 추정했다.
13시간 전
[ SMM 분석 ] 19개 구리 제련소의 2026년 반기 보고서 한눈에 보기
13시간 전
[ SMM 분석 ] 19개 구리 제련소의 2026년 반기 보고서 한눈에 보기
더 보기
[ SMM 분석 ] 19개 구리 제련소의 2026년 반기 보고서 한눈에 보기
[ SMM 분석 ] 19개 구리 제련소의 2026년 반기 보고서 한눈에 보기
13시간 전
MMG, 보츠와나 코에마카우 확장 지원 위해 6,400만 달러 규모 장비 주문
15시간 전
MMG, 보츠와나 코에마카우 확장 지원 위해 6,400만 달러 규모 장비 주문
더 보기
MMG, 보츠와나 코에마카우 확장 지원 위해 6,400만 달러 규모 장비 주문
MMG, 보츠와나 코에마카우 확장 지원 위해 6,400만 달러 규모 장비 주문
에피록이 MMG 리미티드와 광산 계약업체인 차이나 화예, 23MCC로부터 보츠와나 코에마카우 구리 광산 확장을 지원하기 위한 지하 채굴 장비 주문을 약 6억 1천만 크로나(6,400만 달러) 규모로 수주했다. 이번 주문에는 갱도 굴착 드릴, 생산 드릴, 케이블 볼팅 장비, 로더, 지하 광산 트럭과 함께 원격 제어 시스템, 예비 부품, 교육, 현장 기술 지원이 포함된다. 이 장비는 MMG가 진행 중인 코에마카우 확장을 지원할 예정이며, 이를 통해 정광 내 구리 금속 연간 생산 능력을 약 6만 톤에서 13만 톤으로 늘리는 것이 목표다. 이 프로젝트에는 연산 450만 톤 규모의 새로운 처리 공장 건설이 포함되어 총 처리 능력을 800만 톤 이상으로 끌어올리게 되며, Zone 5 North, Mango, Zeta North-East 개발도 함께 진행된다. 확장 프로젝트의 첫 구리 정광 생산은 2028년 상반기로 예상된다. 에피록은 새로운 지하 장비의 인도가 2026년 4분기에 시작되어 2028년 2분기까지 완료될 예정이며, 이는 확장 일정과 대체로 일치한다고 밝혔다. 주문된 장비에는 부머 갱도 굴착 드릴, 심바 생산 드릴, 케이블텍 케이블 볼팅 장비, 스쿱트램 로더, 마인트럭 지하 트럭이 포함되며, 일부 장비는 자동화 및 원격 제어 운전이 가능하도록 구성된다. 이번 장비 주문은 이미 승인된 코에마카우 확장의 또 다른 실행 이정표로, 새로운 생산 목표가 아니다. 조달이 진행되고 장비 인도가 2028년 2분기까지 예정된 가운데, 프로젝트는 MMG가 계획한 정광 내 구리 생산 능력 연간 13만 톤 달성을 향해 계속 진전되고 있다. 이번 확장은 보츠와나 칼라하리 구리 벨트에서 코에마카우의 구리 생산 능력을 대폭 확대하려는 계획을 의미한다.
15시간 전