June N-type Cell Production at 47 GW, Production Cuts and Halts to Continue Amid Oversupply [SMM Analysis]

Telah Terbit: Jun 12, 2024 14:02
According to the latest survey by SMM, from May to June, some solar cell companies could not withstand the falling prices and chose to reduce or even halt production. However, some companies increased production against the trend, mainly due to the concentrated commissioning of new and upgraded TOPCon solar cell capacity in Q2 and early Q3 of 2024. In May and June, solar cells were still in a phase of inventory accumulation, and the trend of production cuts and halts will continue in June.

According to the latest survey by SMM, from May to June, some solar cell companies could not withstand the falling prices and chose to reduce or even halt production. However, some companies increased production against the trend, mainly due to the concentrated commissioning of new and upgraded TOPCon solar cell capacity in Q2 and early Q3 of 2024. In May and June, solar cells were still in a phase of inventory accumulation, and the trend of production cuts and halts will continue in June.

In May 2024, the operating rate of Chinese solar cell companies was 68.81%, with actual output reaching 62.05 GW, a MoM growth of 0.3% and a YoY increase of 34.45%. N-type cell output was 46.14 GW, a MoM increase of 4.74%, accounting for about 74% of the total output. In contrast, P-type cell output was 15.91 GW, a MoM decrease of 10.77%. Module manufacturers stocked up on cells at low prices in April, leading to high inventories in May. The procurement of cells weakened MoM, and solar cell inventories were high in May. Mainstream producers increased production due to the ramp-up of TOPCon production lines, but some small and medium-sized cell manufacturers lowered operating rates to control inventories.

The beginning of May 2024 saw a sharp decline in PV material prices, with various segments of the PV industry chain falling into losses. Although the demand for N-type cell modules increased faster than expected, the supply growth rate significantly exceeded the demand growth rate, leading to an imbalance. The inventories of the four major battery materials were high, and prices quickly fell below the cost line, highlighting the risks of market liquidity. Following the price drop, a wave of production cuts ensued.
In June, as solar cell manufacturers remain in a loss and order conditions are poor, the scope of production cuts is expected to expand, and small cell manufacturers will gradually stop production. However, the ramp-up of production lines for large cell manufacturers will continue. Overall, the planned production of solar cells in June is 58.69 GW, a MoM decrease of 5.4%, and the actual output may be lower than the planned level, with an operating rate of 63.41%.

The planned production of P-type cells in June is 11.17 GW, and N-type cells are 47.07 GW. The planned production of N-type cells in June varies, with the increase mainly contributed by the ramp-up of TOPCon cells by a top battery maker and the increased production of HJT cells due to boosted demand. The supply from manufacturers that have stopped or reduced production has little impact on the overall market supply and demand. The planned production of N-type modules in June is only about 38 GW, with demand for N-type cells below 40 GW. The oversupply of cells in June will put more pressure on specialized cell manufacturers compared to May. Even the top 5 specialized cell manufacturers will face significant challenges in market liquidity. According to SMM survey and analysis, the scope of production cuts will expand in mid-to-late June, and the actual output in June will be difficult to reach the current planned level.

Pernyataan Sumber Data: Kecuali informasi yang tersedia untuk publik, semua data lainnya diproses oleh SMM berdasarkan informasi publik, komunikasi pasar, dan mengandalkan model database internal SMM. Hanya untuk referensi dan tidak menjadi rekomendasi pengambilan keputusan.

Untuk pertanyaan atau informasi lebih lanjut, silakan hubungi: lemonzhao@smm.cn
Untuk informasi lebih lanjut tentang cara mengakses laporan penelitian kami, hubungi:service.en@smm.cn
Berita Terkait
Wafer and solar cell prices continue to edge down, while glass production cuts support price increases [SMM Weekly Review]
41 menit yang lalu
Wafer and solar cell prices continue to edge down, while glass production cuts support price increases [SMM Weekly Review]
Baca Selengkapnya
Wafer and solar cell prices continue to edge down, while glass production cuts support price increases [SMM Weekly Review]
Wafer and solar cell prices continue to edge down, while glass production cuts support price increases [SMM Weekly Review]
[SMM Weekly Review: Wafer and Solar Cell Prices Continue to Edge Down, Glass Production Cuts Support Price Increases] This week, the overall solar cell market remained subdued, with prices across all sizes generally edging down. Price divergence between upstream and downstream intensified, coupled with early signs of inventory buildup in futures, pushing the market into a phase of consolidation on a subdued note amid tug-of-war dynamics. This week, TOPCon prices across all sizes declined in tandem, with the overall market under pressure. The 210R price range was adjusted to 0.298-0.306 Yuan/W, 183 to 0.298-0.305 Yuan/W, and 210N down to 0.295-0.301 Yuan/W. Currently, mainstream quotations from solar cell plants are concentrated at 0.3-0.31 Yuan/W, but downstream module manufacturers are strongly pushing for lower prices, with procurement expectations continuing to decline and significant resistance to high-price transactions in the market. At this stage, orders below 0.3 Yuan/W generally face cash loss pressure, and solar cell plants are reluctant to take orders. The tug-of-war between upstream and downstream is evident, with overall sluggish transactions. Prices are expected to maintain a subdued consolidation pattern in the short term.
41 menit yang lalu
[Harga Modul PV Terdistribusi Terus Berbeda]
4 jam yang lalu
[Harga Modul PV Terdistribusi Terus Berbeda]
Baca Selengkapnya
[Harga Modul PV Terdistribusi Terus Berbeda]
[Harga Modul PV Terdistribusi Terus Berbeda]
Harga modul distribusi masih bervariasi hari ini, dengan beberapa produsen modul khusus terus mengambil pesanan dengan harga rendah, sementara produsen terintegrasi terkemuka sebagian besar mempertahankan penawaran mereka karena tekanan biaya. Dalam jangka pendek, perusahaan hulu dan hilir diperkirakan akan terus melakukan tawar-menawar harga, dengan tren keseluruhan menunjukkan sedikit stabilisasi. Hari ini, harga modul 210R distribusi berada di 0,714-0,726 yuan/W, untuk sementara stabil.
4 jam yang lalu
[Produsen lapisan atas masih menegosiasikan harga kaca PV]
4 jam yang lalu
[Produsen lapisan atas masih menegosiasikan harga kaca PV]
Baca Selengkapnya
[Produsen lapisan atas masih menegosiasikan harga kaca PV]
[Produsen lapisan atas masih menegosiasikan harga kaca PV]
Harga kaca China tetap stabil sementara hari ini, dengan perusahaan-perusahaan bernegosiasi dengan produsen modul hilir berdasarkan hasil penetapan harga yang ditetapkan pada awal bulan. Pusat harga untuk transaksi kaca yang telah diselesaikan sejauh ini adalah 10-10,3 yuan/m², sementara produsen modul terkemuka masih melakukan tawar-menawar, dengan ekspektasi tingkat harga psikologis di bawah 10 yuan/m².
4 jam yang lalu
June N-type Cell Production at 47 GW, Production Cuts and Halts to Continue Amid Oversupply [SMM Analysis] - Shanghai Metals Market (SMM)