[SMM analysis] the operating rate of aluminum sheet and strip increased significantly in March compared with the previous month, and fell back in April into an established fact.

Đã xuất bản: Apr 13, 2020 19:01 (GMT+8)
SMM conducted a survey of the aluminum plate and strip market in March and learned that the average weighted operating rate of China's aluminum plate and strip industry was 62.25% in March, up 13 percentage points from the previous month, down more than 10 percentage points from the same period last year, and is expected to fall slightly to 61 per cent in April 2020.

SMM conducted a survey of the aluminum plate and strip market in March and learned that the average weighted operating rate of China's aluminum plate and strip industry was 62.25% in March, up 13 percentage points from the previous month, down more than 10 percentage points from the same period last year, and is expected to fall slightly to 61 per cent in April 2020.

Source: SMM

At the beginning of March, most of the production conditions of plate and strip enterprises in the industry returned to normal, and some enterprises were still in a state of semi-shutdown due to less orders and slow rework of employees. The start-up rate in March was higher than that in February, mainly due to the fact that most of the plate and belt enterprises in the industry were on holiday in February due to the influence of the epidemic situation, and the start-up rate was relatively low in March, while in March, with the gradual resumption of work and resumption of production, the start-up rate was also relatively higher, and some of the order production plans delayed during the February holiday were released in March, resulting in a significant increase in the start-up rate in March.

Last year, it is still worse than last year, and the terminal consumer market is limited by the weak performance of the epidemic. According to the order category, the performance of building plate and 3C electronic material is relatively stable, the performance of packaging orders such as tank material is relatively weak, the worst is automobile plate, the domestic automobile industry is depressed in March, and foreign car factories in Japan, Europe and the United States and Europe and the United States have stopped production, which has a direct impact on the export of relevant automobile aluminum and domestic trade orders. In addition, most of the aluminum plate and strip enterprises reported that the severity of the epidemic abroad gradually escalated in the middle and late March, and export orders were significantly affected. Customers have withdrawn orders and delayed pick-up of shipments, or customers have been affected by the foreign epidemic and then reduced their orders for cooperation with themselves. In the aspect of finished product inventory, most of the enterprises feedback that their finished product inventory is high, mainly due to the slow pick-up of end customers, and there is obvious pressure on their own funds.

As far as April is concerned, the current corporate feedback is not optimistic. First of all, the export proportion of large plate and strip enterprises in Shandong, Henan, and Fujian is relatively high, between 30% and 50% as a whole, and about 20% of the indirect exports of small and medium-sized enterprises also exist. However, the epidemic situation has not yet appeared an inflection point overseas, and there is even a further serious trend. Overseas countries have adopted measures to seal off countries and ports, and it seems to have become an established fact that export orders continue to decline from April to May. Against the background of weak domestic trade orders, Foreign trade has made matters worse, and the start-up rate in April is expected to be lower than in March.

(SMM Xuman 021-51595898)

 

Tuyên bố về Nguồn Dữ liệu: Ngoại trừ thông tin công khai, tất cả dữ liệu khác được SMM xử lý dựa trên thông tin công khai, giao tiếp thị trường và dựa trên mô hình cơ sở dữ liệu nội bộ của SMM. Chúng chỉ mang tính chất tham khảo và không cấu thành khuyến nghị ra quyết định.

Để biết thêm thông tin hoặc có thắc mắc gì, vui lòng liên hệ: lemonzhao@smm.cn
Để biết thêm thông tin về cách truy cập báo cáo nghiên cứu, vui lòng liên hệ:service.en@smm.cn
Tin Liên Quan
【SMM Tin nhanh Nhôm】Tỷ lệ tái chế lon nhôm toàn cầu tăng lên 76%, mục tiêu đạt 80% vào năm 2030
3 phút trước
【SMM Tin nhanh Nhôm】Tỷ lệ tái chế lon nhôm toàn cầu tăng lên 76%, mục tiêu đạt 80% vào năm 2030
Đọc thêm
【SMM Tin nhanh Nhôm】Tỷ lệ tái chế lon nhôm toàn cầu tăng lên 76%, mục tiêu đạt 80% vào năm 2030
【SMM Tin nhanh Nhôm】Tỷ lệ tái chế lon nhôm toàn cầu tăng lên 76%, mục tiêu đạt 80% vào năm 2030
Bộ dữ liệu Tái chế Bao bì Đồ uống Toàn cầu 2026 do Liên minh Tuần hoàn Lon Đồ uống Toàn cầu công bố cho thấy tỷ lệ tái chế lon nhôm toàn cầu đã tăng từ 74,8% lên 76%, trong khi tỷ lệ thu gom đạt 77%, tiếp tục dẫn đầu so với các loại bao bì đồ uống chính khác. Chai PET ghi nhận tỷ lệ thu gom và tái chế lần lượt là 69% và 54%, so với 56% và 51% của chai thủy tinh. Bộ dữ liệu bao phủ các thị trường đại diện cho ít nhất 84% doanh số toàn cầu của mỗi loại bao bì. Ngành đang đặt mục tiêu đạt tỷ lệ tái chế 80% đối với lon đồ uống đã qua sử dụng vào năm 2030, tiếp theo là mục tiêu tiến gần 100% vào năm 2050. Ấn Độ, Indonesia, Ả Rập Xê Út, Thổ Nhĩ Kỳ và Nigeria nằm trong số các thị trường đồ uống mới nổi được nhấn mạnh cần cải thiện hơn nữa hệ thống thu gom và tái chế.
3 phút trước
【SMM Aluminum Flash News】Cameroon’s Minim Martap Bauxite Project Faces Funding Setback, First Shipment Delayed
4 phút trước
【SMM Aluminum Flash News】Cameroon’s Minim Martap Bauxite Project Faces Funding Setback, First Shipment Delayed
Đọc thêm
【SMM Aluminum Flash News】Cameroon’s Minim Martap Bauxite Project Faces Funding Setback, First Shipment Delayed
【SMM Aluminum Flash News】Cameroon’s Minim Martap Bauxite Project Faces Funding Setback, First Shipment Delayed
Canyon Resources’ Minim Martap bauxite project in Cameroon faces fresh uncertainty after AFG Bank Cameroon suspended further drawdowns from the project’s syndicated financing facility on August 24, pending a review of its development schedule, financial model and economic assumptions. Canyon has confirmed that Phase 1 will not meet its previous timetable and has withdrawn its Q4 2026 first-shipment target, with no new date announced. Minim Martap has a mineral resource of around 1.1 billion tonnes and an ore reserve of 144 million tonnes, averaging approximately 51% alumina and 2% silica. Canyon held around AUD 31 million in cash at the end of July, while approximately $75 million had already been drawn from the CFA 82 billion syndicated facility. The company is reducing non-essential spending while reassessing the project’s development and funding pathway.
4 phút trước
【SMM Tin nhanh Nhôm】Caterpillar ra mắt ba dòng máy mới tại Ấn Độ phục vụ khai thác mỏ và hạ tầng
4 phút trước
【SMM Tin nhanh Nhôm】Caterpillar ra mắt ba dòng máy mới tại Ấn Độ phục vụ khai thác mỏ và hạ tầng
Đọc thêm
【SMM Tin nhanh Nhôm】Caterpillar ra mắt ba dòng máy mới tại Ấn Độ phục vụ khai thác mỏ và hạ tầng
【SMM Tin nhanh Nhôm】Caterpillar ra mắt ba dòng máy mới tại Ấn Độ phục vụ khai thác mỏ và hạ tầng
Caterpillar đã ra mắt máy xúc thủy lực Cat 355, máy ủi Cat D5 và máy san Cat 120 GC tại bauma CONEXPO India 2026, hướng đến các ứng dụng khai thác mỏ, hạ tầng quy mô lớn và xây dựng đường bộ. Cat 355 được trang bị động cơ C13B và hệ thống điện thủy lực với các tùy chọn gầu lên đến 4,5 m³, trong khi Cat D5 sử dụng động cơ C7.1 công suất 170 mã lực và có lưỡi ủi 4,3 m³. Cat 120 GC được thiết kế chủ yếu cho các ứng dụng bảo trì đường bộ và san hoàn thiện. Các sản phẩm mới này tiếp tục mở rộng danh mục thiết bị của Caterpillar cho lĩnh vực khai thác mỏ và hạ tầng tại Ấn Độ.
4 phút trước