The stainless steel peak season is not performing well, and the price of nickel pig iron is facing downward pressure

Опубликовано: Sep 8, 2024 21:12
During the past week, the average price of SMM 8-12% high-nickel pig iron fell to RMB 999.9 per nickel point, a decrease of RMB 1.8. Similarly, the Indonesian NPI FOB index decreased by $0.6 per nickel point. The overall trend shows weakening prices for nickel pig iron. Domestically, high nickel ore prices and anticipated weaker nickel pig iron prices are reducing smelter profits, limiting significant supply increases. In Indonesia, early commissioning of new production lines has been offset by low raw material inventories, also constraining supply growth. On the demand side, despite a poor start to the peak season for stainless steel, demand for nickel pig iron is supported by restocking for National Day holidays and increased production in the latter half of the year. The market faces pressure from significant price drops in stainless steel and nickel. The high-nickel pig iron discount compared to electrolytic nickel decreased, reflecting intensified market panic due to declining stainless steel prices and macroeconomic pessimism. Pure nickel prices also dropped, influenced by weaker-than-expected economic data. In the short term, while cost factors may offer some support to high-nickel pig iron prices, they remain susceptible to further declines driven by broader economic factors. The price differential between nickel pig iron and electrolytic nickel is expected to narrow further next week

During the week, the average price of SMM 8-12% high-nickel pig iron was RMB 999.9 per nickel point (ex-factory, tax included), down by RMB 1.8 per nickel point compared to last week. Meanwhile, the Indonesian NPI FOB index also decreased by $0.6 per nickel point from last week. Overall, the transaction prices of nickel pig iron began to weaken this week.

From the supply side, domestically, nickel ore prices remain high while nickel pig iron prices are expected to weaken, constraining the profit margins of smelters. Considering these factors, the supply of domestic nickel pig iron is not expected to increase significantly in September. In Indonesia, new nickel pig iron production lines were commissioned ahead of schedule, but the release of Indonesian nickel ore has not met expectations, leading to low raw material inventory levels at smelters and difficulty ramping up capacity. Therefore, the supply increase is quite limited.

On the demand side, the start of the traditional peak season for stainless steel was not smooth, with spot prices dropping significantly. However, due to pre-holiday restocking for the upcoming National Day holidays and the fact that the second half of the year is traditionally a production peak season, stainless steel output is still expected to increase significantly, which sustains demand for nickel pig iron.

In summary, although there are signs of simultaneous increases in both the supply and demand of nickel pig iron, the deep decline in stainless steel and nickel prices has put substantial pressure on nickel pig iron prices. In the short term, nickel pig iron prices may tend to run weak.

Additionally, during the week, the average discount of high-nickel pig iron relative to electrolytic nickel was RMB 260.6 per nickel point, narrowing by RMB 48.9 per nickel point compared to last week's discount. The price of high-nickel pig iron started to decline from the beginning of the week. The unsmooth start of the traditional "Golden September, Silver October" period and the expanding decline in stainless steel prices have intensified market panic, with this negative feedback also spreading to the raw material market, leading to further price declines.

Regarding pure nickel, the nonfarm payroll data and macroeconomic indicators for August were below expectations, exerting a bearish impact on the non-ferrous metals market. Pure nickel prices dropped considerably, with LME nickel falling below $16,000 per ton, and SHFE nickel dropping below RMB 125,000 per ton during the week. The discount of high-nickel pig iron relative to electrolytic nickel began to narrow.

In the short term, although the cost support for high-nickel pig iron limits its price decline, nickel prices may still face a downward risk influenced by macroeconomic factors. It is expected that the price gap between nickel pig iron and electrolytic nickel will continue to narrow next week compared to this week.

Заявление об источниках данных: За исключением общедоступной информации, все остальные данные обрабатываются SMM на основе общедоступной информации, рыночного общения и с опорой на внутреннюю базу данных и модели SMM. Они приведены только для справки и не являются рекомендациями для принятия решений.

По любым вопросам или для получения дополнительной информации, пожалуйста, свяжитесь: lemonzhao@smm.cn
Для получения дополнительной информации о доступе к нашим исследовательским отчётам обращайтесь:service.en@smm.cn
Связанные новости
[SMM Stainless Steel Flash] Правило ЕС о плавке и разливке изменит прослеживаемость цепочки поставок нержавеющей стали
4 часов назад
[SMM Stainless Steel Flash] Правило ЕС о плавке и разливке изменит прослеживаемость цепочки поставок нержавеющей стали
Читать далее
[SMM Stainless Steel Flash] Правило ЕС о плавке и разливке изменит прослеживаемость цепочки поставок нержавеющей стали
[SMM Stainless Steel Flash] Правило ЕС о плавке и разливке изменит прослеживаемость цепочки поставок нержавеющей стали
С 1 октября 2026 года импортеры ЕС обязаны декларировать и подтверждать, где импортируемая сталь была первоначально выплавлена и разлита, как правило, с помощью сертификата заводских испытаний, содержащего страну выплавки и разливки и номер плавки. Правила не изменяют существующие объемы квот и не ограничивают доступ на рынок из конкретных стран, а годичный переходный период допускает альтернативную документацию, если сертификаты заводских испытаний недоступны. Однако с октября 2027 года Комиссия будет учитывать собранные данные о стране выплавки и разливки при принятии решений о распределении квот по странам, а к июню 2028 года проведет дополнительную оценку того, должна ли сама страна выплавки и разливки стать основанием для доступа к квотам. Эти правила имеют серьезные последствия для цепочек поставок нержавеющей стали в Азии, где широко распространена трансграничная переработка. В 2025 году Индонезия экспортировала в Италию около 330 тыс. тонн слябов из нержавеющей стали, при этом поставки в ЕС в текущем году уже превысили 123 тыс. тонн; поскольку слябы в настоящее время не подпадают под меры торговой защиты, маршрут импорта индонезийских полуфабрикатов для местной переработки может столкнуться с более пристальным контролем по мере углубления прослеживаемости страны выплавки и разливки.
4 часов назад
【SMM Никель: экспресс】Индонезия подтверждает детали реализации послаблений DHE SDA
20 часов назад
【SMM Никель: экспресс】Индонезия подтверждает детали реализации послаблений DHE SDA
Читать далее
【SMM Никель: экспресс】Индонезия подтверждает детали реализации послаблений DHE SDA
【SMM Никель: экспресс】Индонезия подтверждает детали реализации послаблений DHE SDA
Индонезия подтвердила детали реализации статьи 18A Постановления Правительства (PP) № 21/2026, которая вступила в силу для экспортных таможенных деклараций (PPE) с 1 сентября 2026 года. Правительство определило 64 экспортёра горнодобывающей отрасли, или около 12% из 537 проверенных экспортёров, как соответствующих критериям на текущий момент. Соответствующие требованиям экспортёры должны быть зарегистрированы как индонезийские PT, работать в горнодобывающем секторе и иметь как минимум одного акционера из указанных стран — США, Китая, Гонконга, Австралии или Канады — с долей не менее 10%. Список соответствующих требованиям будет пересматриваться ежемесячно. Правительство также назначило 15 банков с иностранным участием для размещения DHE SDA в соответствии со статьёй 18A, включая пять государственных банков и 10 частных банков. Это позволяет соответствующим требованиям экспортёрам размещать обязательные DHE SDA в назначенных частных банках, обеспечивая большую гибкость в управлении экспортной выручкой.
20 часов назад
Данные: динамика рынка SHFE, DCE (3 сентября)
21 часов назад
Данные: динамика рынка SHFE, DCE (3 сентября)
Читать далее
Данные: динамика рынка SHFE, DCE (3 сентября)
Данные: динамика рынка SHFE, DCE (3 сентября)
В следующей таблице показано движение черных и цветных металлов на SHFE и DCE 3 сентября 2026 года.
21 часов назад